18 mm Flat Cold Chisel

The Teng Tools CC150F is a chisel for hard materials, with a flat 18 mm (0.71 in) cutting edge, 150 mm (5.9 in) long and weighing 178 g (6.3 oz). It is made with special tempered steel construction and a hardened cutting edge, which Teng Tools specifies for longer life.

Teng Tools specifies it for shaping, cutting and chipping hard materials such as metal, stone and concrete. In the workshop that means splitting a seized nut, cutting off a rivet head and chipping spatter, scale or slag from a part. On site the same edge chips back concrete, rakes out a mortar joint and trims stone to fit.

The narrow 18 mm edge concentrates each hammer blow on a small area and reaches into corners, slots and the gaps behind brackets. At 150 mm it is the compact size, easy to carry in a pouch or keep in a toolbox drawer for quick jobs at the bench.

This is the same chisel Teng Tools includes in its TTEPS12, TTPC09, WRPC10, PCX05, TEDPC14 and TTEX18 sets, so it also replaces the chisel from one of those sets.

What you get: one Teng Tools CC150F chisel, flat 18 mm edge, 150 mm (5.9 in) long. The hammer is not included. Wear eye protection when striking.

• Special tempered steel construction with a hardened cutting edge, which Teng Tools specifies for longer life. The flat edge is 18 mm (0.71 in) wide, a narrow width that puts each blow on a small area and still fits into a tight corner, a slot or the gap behind a flange or a bracket.
• Teng Tools specifies it for shaping, cutting and chipping hard materials such as metal. Use it as a metal chisel to split a seized nut, cut off a rivet head or nick a light section, or as a chipping chisel to knock weld spatter, scale and slag off a part before it is dressed and fitted.
• The same hardened edge is rated for stone and concrete, so it doubles as a masonry chisel. Chip back a high spot on a slab, open a small chase for a cable or pipe, rake out a mortar joint or trim a stone to fit. One flat edge that works as a concrete chisel and a stone chisel saves carrying a second one.
• The chisel is 150 mm (5.9 in) long and weighs 178 g (6.3 oz). That compact size fits a tool pouch, a toolbox drawer or a service truck bin, and suits short, controlled cuts on the bench where a longer chisel would be awkward to hold and strike close to the work.
• Teng Tools includes this chisel in its TTEPS12, TTPC09, WRPC10, PCX05, TEDPC14 and TTEX18 sets, so it is the direct replacement when the chisel from one of those sets is lost or worn. Strike it with a hammer from your own kit; the hammer is not included. Wear eye protection when cutting or chipping.

Part number: CC150F