25 mm Flat Cold Chisel

The Teng Tools CC200F is a flat-edged steel chisel with a 25 mm (just under 1 inch) cutting edge, 200 mm (7.9 inch) long and weighing 401 g (14.1 oz). Teng Tools makes it from high carbon steel, with special tempered steel construction and a hardened cutting edge for longer life.

It is specified for shaping, cutting and chipping hard materials such as metal, stone and concrete. In the workshop that means cutting sheet and light bar, removing a fastener that is too damaged to turn, and chipping off spatter, scale or excess material. On site the same edge chips concrete, cleans out a mortar joint and shapes stone to fit.

The 200 mm length gives a full grip with your hand held back from the edge, and the weight of the steel carries each hammer blow through to the work. It is a size that fits a toolbox drawer, a site bag or a service truck bin, and a flat 25 mm edge is a general-purpose width for both broad cuts and tight corners.

This is the same chisel Teng Tools includes in its TTEPS12, TTPC09, WRPC10, TEDPC14 and TTEX18 sets, so it also replaces the chisel from one of those sets.

What you get: one Teng Tools CC200F chisel, flat 25 mm edge, 200 mm (7.9 inch) long. The hammer is not included. Wear eye protection when striking.

• Teng Tools makes this chisel from high carbon steel with special tempered steel construction and a hardened cutting edge for longer life. The flat edge is 25 mm (just under 1 inch) wide, a general-purpose width that covers a broad cut on plate or concrete and still fits into a corner, a joint or the gap behind a bracket.
• Teng Tools specifies it for shaping, cutting and chipping hard materials such as metal. Use it as a metal chisel to cut through sheet and light bar, to remove a rusted or damaged fastener that a wrench can no longer turn, or to chip off spatter, scale and excess material when a part needs dressing before it is fitted.
• The same edge is rated for stone and concrete, so it works as a masonry chisel as well. Chip back a high spot of concrete, open a channel for a pipe or cable, clean mortar from a joint, or shape a stone to fit. One chisel that is a stone chisel and a concrete chisel saves carrying a second striking tool to a job.
• 200 MM (7.9 INCH) LENGTH, 401 G: At 200 mm overall the chisel gives a full hand grip with your knuckles held back from the work, and the 401 g (14.1 oz) of steel carries the hammer blow through to the edge. It is long enough for controlled two-handed work at the bench and still short enough to fit a toolbox drawer, a site bag or a service truck bin.
• Teng Tools includes this chisel in its TTEPS12, TTPC09, WRPC10, TEDPC14 and TTEX18 sets, so it is the direct replacement when the chisel from one of those sets is lost or worn out. Strike it with a hammer from your own kit; the hammer is not included. Wear eye protection when cutting or chipping hard materials.

Part number: CC200F