26 mm Flat Cold Chisel

The Teng Tools CC240F is a chisel for hard materials, with a flat 26 mm (1.02 in) cutting edge, 240 mm (9.4 in) long and weighing 265 g (9.3 oz). Teng Tools makes it from high carbon steel, with special tempered steel construction and a hardened cutting edge for longer life.

It is specified for shaping, cutting and chipping hard materials such as metal, stone and concrete. In the workshop that means shearing a rusted bolt or a rivet, splitting a seized nut and chipping spatter, scale or slag from a weld. On site the same edge chips concrete, cleans out a mortar joint and squares stone to fit.

The 240 mm length is the reason to choose this size. It keeps the holding hand well back from the edge and reaches into recesses and channels, while the broad 26 mm edge takes a wide bite with each blow. It still fits a toolbox drawer, a site bag or a service truck bin.

This is the same chisel Teng Tools includes in its TEDPC14 set, so it also replaces the chisel from that set.

What you get: one Teng Tools CC240F chisel, flat 26 mm edge, 240 mm (9.4 in) long. The hammer is not included. Wear eye protection when striking.

• Teng Tools makes this chisel from high carbon steel, with special tempered steel construction and a hardened cutting edge for longer life. The flat edge is 26 mm (1.02 in) wide, a broad edge that takes a wide bite on plate, a slab edge or a mortar bed with each blow of the hammer.
• Teng Tools specifies it for shaping, cutting and chipping hard materials such as metal. Use it as a metal chisel to shear a rusted bolt or a rivet, split a seized nut, or as a chipping chisel to clear weld spatter, scale and slag along a seam before the part is dressed, painted or fitted.
• The same edge is rated for stone and concrete, so it works as a masonry chisel as well. Chip back a high spot on a slab, open a chase for a pipe or cable, clean out a mortar joint or square off a stone. One edge that serves as a concrete chisel and a stone chisel saves carrying a second striking tool to the job.
• The chisel is 240 mm (9.4 in) long and weighs 265 g (9.3 oz). The extra length keeps the hand that holds it further back from the edge and the work, and reaches into a recess, down a channel or over an obstruction that a shorter chisel cannot clear while still leaving room to swing the hammer.
• Teng Tools includes this chisel in its TEDPC14 set, so it is the direct replacement when the long chisel from that set is lost or worn. Strike it with a hammer from your own kit; the hammer is not included. Wear eye protection when cutting or chipping hard materials such as metal, stone or concrete.

Part number: CC240F