25 mm Flat Cold Chisel

The Teng Tools CC250F is a flat-edged steel chisel with a 25 mm (just under 1 inch) cutting edge and a long 250 mm (9.8 inch) body, weighing 505 g (17.8 oz). Teng Tools makes it from high carbon steel, with special tempered steel construction and a hardened cutting edge for longer life.

Teng Tools specifies it for shaping, cutting and chipping hard materials such as metal, stone and concrete. At the bench it cuts sheet and light bar, removes fasteners too damaged to turn and chips off spatter, scale and excess material. On site it chips concrete, opens a chase for a pipe or cable, cleans mortar from a joint and shapes stone.

The extra length is the reason to choose it: your hand sits further from the hammer blow, the edge reaches into recesses and behind frames, and the added weight of steel drives each strike through to the work. It still fits a site bag, a long toolbox drawer or a service truck bin.

This is the same chisel Teng Tools includes in its TTEPS15, WRPC10 and TEDPC14 sets, so it also replaces the chisel from one of those. A shorter version is available as the CC200F.

What you get: one Teng Tools CC250F chisel, flat 25 mm edge, 250 mm (9.8 inch) long. The hammer is not included. Wear eye protection when striking.

• Teng Tools makes this chisel from high carbon steel, with special tempered steel construction and a hardened cutting edge for longer life. The flat edge is 25 mm (just under 1 inch) wide, wide enough to take a broad bite out of plate, a weld or a concrete surface and narrow enough to work into a corner or along a joint.
• 250 MM (9.8 INCH) FOR REACH AND CLEARANCE: The longer body puts more distance between your hand and the hammer blow, and reaches into a recess, a channel or the back of a frame that a short chisel cannot. At 505 g (1.1 lb) there is more steel behind the edge to drive each strike through. A sensible choice when the work is deep, awkward or at arm's length.
• Teng Tools specifies it for shaping, cutting and chipping hard materials such as metal. As a metal chisel it cuts through sheet and light bar, takes off a rusted or damaged fastener that no wrench will turn, and chips spatter, scale and excess material from a part before it is fitted or welded.
• The same hardened edge is rated for stone and concrete, so it doubles as a masonry chisel on site. Chip back concrete, cut a chase for pipe or cable, clean out a mortar joint or dress a stone to fit. Working as a stone chisel and a concrete chisel, it saves carrying a second striking tool between the workshop and the job.
• Teng Tools includes this chisel in its TTEPS15, WRPC10 and TEDPC14 sets, so it is the direct replacement when the chisel from one of those sets goes missing or wears out. If you want a shorter version for a drawer, the same chisel is made in a shorter length as CC200F. The hammer is not included; wear eye protection when striking.

Part number: CC250F